求教:硬盘这样的错误应该如何修复,才能安装上系统?

meng699 · 发表于 2009-5-8 08:19:22

电脑是sata硬盘.C盘原来是NTFS格式.
本来能用的系统,但有这样的毛病:IE中如何打开Flash,就会蓝屏.只得不显示Flash,近来由于用得不顺手,决定重装.
我先进入PE,格式化C,然后GHOST,启动不了.
后又经种种方法重装,都不行.
现在的毛病是这样的,我用Scandisk命令扫描硬盘.出现下面的提示:
Scandisk cannot read from the last cluster on drive C,This cluster is either damaged,or your system is not configured proerly.Drive C may need to have Logical Block Addressing(LBA) enabled to work properly,or its disk partition may be incorrectly marked as a non_LBA partition.Data loss can occur if your LBA setting or disk partition type for this drive is misconfigured.

Check your computer's BIOS setup utility,or contact your computer manufacturer, or have your computer checked by a qualified computer hardware technician.

If you are sure your drive is comfigured correctly,click Continue to have ScanDisk check drive C for errors.

启动PM，没进入程序就出现提示：
Norton Partitionmagic 已侦测到起始于磁蝶1扇形磁区63上的分割磁区有错误110。分割磁区表格中的分割磁区长度不正确。
CHS长度为44050167,LBA长度为44050144,以及档案系统长度为44050144.Norton Partitionmagic 已经决定长度可变更为正确的值44050167.
您要Norton Partitionmagic 来修正这个错误吗？

同样错误提示三次，我都点修复。
进入PM后，发现原来的分区全没有了。提示是“分割表错误”。但重启进入PE，可仍可看到硬盘数据。
请问硬盘高手,现在应该怎么办?如何才能修复硬盘错误,顺利安装上系统?
格式化后原来的用的科教2000的注册码会不会失效?